Skip to content

Documentation

Act on a detail without an extraction

Reference an element or a region on any page, then give your agent an instruction. No extraction is counted.

Acting on a detail is a shortcut, not a required step. On any open page, click an element to reference it, then give your instruction. A drag targets a precise region. Nothing is analyzed: this is neither a new selection nor an extraction.

The action consumes no credit: it skips the analysis and goes straight to the local session.

Start

  1. Open the page in Brave or Chrome.
  2. Open the Cadralia panel.
  3. Click Act on a detail.

The page enters marking mode. A click targets an element. A drag targets a free region. Each target gets a number: [1], [2], and so on, up to twenty marks.

The marking bar shows the number of targets. Finish or Escape leaves marking mode and returns to the panel.

Write the instruction

Marks are inserted at the cursor position in a single instruction. You can therefore write a relationship, not just a list:

Put [1] on the same row as [2] and align both on the 8 px grid.

An instruction that references at least one mark is required to send. The panel shows each target with its type, selector and text when it exists. You can remove a target before sending.

Send

  1. Choose the target session in the panel.
  2. Check the instruction and the marks.
  3. Click Send the instruction.

Your agent receives:

  • the page as rendered, with the marks visible;
  • each target: selector, tag, text, role, accessible label and geometry;
  • the computed styles of the marked elements;
  • your instruction.

The extraction tree and the original handoff are not repeated. The action only concerns what you just marked.

What happens on the page

Marking mode is isolated from the page: your clicks do not trigger the page handlers and do not close an open modal.

If the page reloads or changes route, the marks are cleared. Return to the panel and click Act on a detail again. A page that does not load the content script, such as chrome:// or an extension gallery, cannot be marked.

When to use it

  • Reference an element seen on another page without running the full extraction.
  • State a relationship between two elements, such as a button and its label.
  • Evolve a component that is already in place without going through the extraction.
  • Give your agent a precise target when a written description would be longer than a mark.

To compare a render with the reference crop, see Check the render.